3
Use of thermistors in LED thermal control
The simplest implementation of LED thermal control using a thermistor employs a PTC device. This is a thermal resettable fuse that can be used as either an overcurrent or a thermal protection device if mounted close to the LED. Safety considerations need to be taken into account here. The PTC increases its nominal low resistance with temperature to a high not open circuit condition at its trip point. So it does not isolate. The PTC is a non-linear device with an effective switch action at around 125°C. But up to that point the temperature is not being reduced in a controlled way in-accordance with the LED current de-rating graph. Also, does the lighting strategy want a zero light output due to over temperature conditions? The primary purpose of the LED is illumination not self protection. Overheating and cooling down can cause a thermal cycling resulting in low frequency flashing of the LED.
NTC thermistors exhibit continuous but non-linear variation of resistance over temperature. The amount of variation with temperature is dependent on the βvalue of the particular NTC device, with typical figures being 2700, 3590 and 4400. The nominal resistance value is usually quoted at 25°C and devices are available from 10’s of ohms to mega ohms. These are usually used as a control element in conjunction with a linear or switching regulator. The variation of the resistance with temperature can be calculated from a formula but is usually presented as a table of resistance values over the range -40°C to +150°C. Table 1 shows the resistance values of a typical 10k? nominal thermistor with three different ß values.
Table 1 - Resistance values of a typical 10k? nominal thermistor with three different ß values
© 2006 Zetex Semiconductors plc
百度搜索“77cn”或“免费范文网”即可找到本站免费阅读全部范文。收藏本站方便下次阅读,免费范文网,提供经典小说教育文库thermal_considerations_for_high_brightness_LEDs_5(2)在线全文阅读。
相关推荐: