77范文网 - 专业文章范例文档资料分享平台

大管轮轮机英语综合(33-48期)(16)

来源:网络收集 时间:2021-02-21 下载这篇文档 手机版
说明:文章内容仅供预览,部分内容可能不全,需要完整文档或者需要复制内容,请下载word后使用。下载word有问题请添加微信号:或QQ: 处理(尽可能给您提供完整文档),感谢您的支持与谅解。点击这里给我发消息

大管轮轮机英语综合

11. The engine speed at which resonance can occur is termed ______.

A. maximum speed B. full speed C. sea speed D. critical speed

12. A crankshaft whose center of gravity coincides with its center line is said to be______.

A. dynamically balanced B. statically balanced C. counter balanced D. resonantly balanced 13. ______ the repair in so short a time is unknown to us.

A. How they finished B. How did they finished C. That how they finished D. That how did they finished

14. The principle of hydrostatic lubrication has been applied to the cross-head using______.

A. high pressure lubricators B. tie rods C. fuel injectors D. fuel valves 15. Load control on a diesel engine is accomplished by______.

A. regulating the speed of the turbocharger B. rotating the fuel injector pump plunger

C. regulating the speed of the fuel oil transfer pump D. changing engine timing

16. A reduction in load on a diesel engine results in ______of speed of the crankshaft.

A. a reduction B. an increase C. an outing D. a downwards

17. Which of the listed statements is correct concerning the starting of centrifugal pumps?

A. They should always be started with the discharge valve closed. B. They should always be started with the discharge valve opened. C. A priming pump is always required to flood the impeller suction. D. They should always be started with the sealing line valves closed.

18. The ______discharge a nearly constant amount of liquid regardless of pressure.

A. mixed-flow pump B. axial-flow pump C. centrifugal pump D. displacement pump 19. In an auxiliary boiler steam and water system, the highest pressure will be in the ______.

A. steam stop valve B. dry pipe C. feedwater system D. generating tubes 20. The rate of heat transfer in a water-tube auxiliary boiler can be increased by ______.

A. operating the boiler at less than normal water level B. installing fins on the firesides of water-tubes C. increasing the amount of excess air to the burners

D. treating the boiler water with chemical oxygen scavengers

21. High-speed rotation in a centrifugal purifier can produce a force______ the force of gravity.

A. many thousand times larger than B. the same as

C. many thousand times smaller than D. none of the above

22. When in operation, it is unavoidable that a small amount of oil ______through leakage, and in

order to compensate for these leaks the system is connected to a feed pump. A. escapes B. overheats C. expands D. accelerates

23. Grease the roller bearings with H.P. gun . In the sentence "H.P." means______.

A. horse power B. high pressure compressor C. hand pump D. high pressure 24. The oil sludge is burnt in the _____onboard. I ll show you the ashes.

A. boiler B. main engine C. auxiliary engine D. incinerator

25. The term ‘ discharge ’ , as it applies to the pollution regulations, means ______.

A. spilling B. leaking C. dumping D. all of the above

26. When normal operating pressure is applied to the hydraulic oil used in a high-pressure system, the

oil ______.

A. viscosity will decrease B. volume will increase

C. volume will decrease D. pour point will be reduced

27. ______are used for hauling in or letting out the wires which fasten the ship to the shore. A. Cargo winches B. Mooring winches C. Windlasses D. Cargo hatches

28.

Which of the following hydraulic systems is not one of the three sub-division of the hydraulic drive system?

A. constant pressure system B. variable pressure system C. variable displacement system D. constant volume system

29.

With reference to rules governing steering gear, which one of the following rules is incorrect ? A. It is required that all ships are provided with two independent steering gear systems that is one main and one auxiliary.

B. The auxiliary gear could be power operated in passenger ships.

C. The auxiliary gear must be of adequate strength and sufficient to steer a ship at navigable speed.

D. All moving parts of the steering gear must be guarded against any possible damage. 30. Broken valve strips in an operating low pressure, air compressor will cause ______. A. an immediate crankcase explosion B. oil contamination in the compressed air

C. a decrease in compressor capacity D. no immediate loss of the compressed air capacity 31.

Condensate must be drained from the intercooler and after-coolers of an air compressor because ______.

A. the cooling effect of the condensate reduces the compressor's efficiency B. a danger of explosion exists whenever water is present in a compressor C. water causes erratic operation of pneumatic components

D. the volumetric capacity of the first stage is reduced if water remains

32.

If the head pressure of a reciprocating refrigeration compressor is excessive, ______. A. the relief valve should open before the high pressure cutout

B. the relief valve should open and allow the excess refrigerant to flow to the receiver C. the high pressure cutout switch should operate before the relief valve opens D. you should close the suction valve

33. Sludge may form in the crankcase of an air conditioning compressor as a result of ______. A. bubbling refrigerant B. overheating and oxidation

C. lowered operating temperatures D. reducing the cloud or flash point 34. A feeler or thermal bulb is used for the expansion valve to ______. A. detect the temperature B. detect the pressure

C. heat the refrigerant D. accelerate the refrigerant

35.

The dew point of air is reached when the wet bulb temperature is ______.

A. twice the dry bulb temperature B. 10℃ above the dry bulb temperature C. 5℃ above the dry bulb temperature D. equal to the dry bulb temperature 36. ______ is used to produce electric power.

A. An alternator B. A fresh water generator C. A compressor D. A clarifier 37. In order to change the direction of rotation of a D.C. motor ______.

I. the field leads must be changed ; II. the input leads must be changed A. I only B. II only C. either I or II D. neither I or II

38.

Which of the following should be the FIRST step in removing a generator from parallel operation? A. Trip the generator off the switchboard.

百度搜索“77cn”或“免费范文网”即可找到本站免费阅读全部范文。收藏本站方便下次阅读,免费范文网,提供经典小说教育文库大管轮轮机英语综合(33-48期)(16)在线全文阅读。

大管轮轮机英语综合(33-48期)(16).doc 将本文的Word文档下载到电脑,方便复制、编辑、收藏和打印 下载失败或者文档不完整,请联系客服人员解决!
本文链接:https://www.77cn.com.cn/wenku/jiaoyu/1188651.html(转载请注明文章来源)
Copyright © 2008-2022 免费范文网 版权所有
声明 :本网站尊重并保护知识产权,根据《信息网络传播权保护条例》,如果我们转载的作品侵犯了您的权利,请在一个月内通知我们,我们会及时删除。
客服QQ: 邮箱:tiandhx2@hotmail.com
苏ICP备16052595号-18
× 注册会员免费下载(下载后可以自由复制和排版)
注册会员下载
全站内容免费自由复制
注册会员下载
全站内容免费自由复制
注:下载文档有可能“只有目录或者内容不全”等情况,请下载之前注意辨别,如果您已付费且无法下载或内容有问题,请联系我们协助你处理。
微信: QQ: